GUTTER. Diameter: 125mm or 150mm. Length: 3m or 4m. 5 units in pack.
GUTTER HOLDER SMALL – gutter holder is made of seamless steel strip. It is used to fix a gutter to a wall or ledge. Gutter holder follows the shape of a gutter and adjoins to it very accurately. It has pins for mounting and dismounting. Holders are painted with a help of powder coating; their colours correspond to the colours of the available rain water discharge system.
GUTTER HOLDER L-160 – gutter holder is made of seamless steel strip. It is used to fasten a curved holder to a strip of board. Gutter holder follows the shape of a gutter and adjoins to it very accurately. It has pins for mounting and dismounting. Holders are painted with a help of powder coating; their colours correspond to the colours of the available rain water discharge system.
GUTTER HOLDER L-210 – gutter holder is made of seamless steel strip. It is used to fasten a curved holder to a strip of board Gutter holder follows the shape of a gutter and adjoins to it very accurately. It has pins for mounting and dismounting. Holders are painted with a help of powder coating; their colours correspond to the colours of the available rain water discharge system.
GUTTER ANGLE INNER 90° is an element made of seamless piece of tin. Angles are necessary to join gutters at corners. Angles make the system integral and completed.
GUTTER ANGLE OUTER 90° – is an element made of seamless piece of tin. Angles are necessary to join gutters at corners. Angles make the system integral and completed.
GUTTER ANGLE OUTER 90° – is an element made of seamless piece of tin. Angles are necessary to join gutters at corners. Angles make the system integral and completed.
GUTTER ANGLE INNER 135° – is an element made of seamless piece of tin. Angles are necessary to join gutters at corners. Angles make the system integral and completed.
GUTTER FINITE ELEMENT – this element is used to close the end of a gutter and not to allow water to leak out. The construction is universal and allows closing a gutter from both right and left side. Besides, it makes rain water discharge system look aesthetically.
GUTTER CONNECTING ELEMENT – connecting element is used to join gutters. It has maximal effective area in comparison to European analogues. Fastening width – 100mm. It has built in 95mm width stopwater with capillary channels. This system is easy to mount.
GUTTER CONNECTOR – is used to join a gutter and a rain water pipe and ensures water running off to a pipe. Gutter connector is easy to build into any place of a gutter. Gutter connectors are made deep pressing.
RAIN WATER PIPE – length: 1m, 2m or 3m. Diameter: 87mm or 100mm.
UPPER ELBOW – is used to join rain water pipes in bending points, when ledges oversail.
RAIN WATER PIPE FINITE ELEMENT – the last element of rain water discharge system that carries water away from the foundation. It has decorative edge at the end.
RAIN WATER PIPE FIXTURING ELEMENT TO WOOD is a cramp fixed with a wedge-type anchor. Good adjoining provides strength and hides joint places. It is made by deep pressing method. It has two fixing points.
RAIN WATER PIPE FIXTURING ELEMENT TO BRICK is a cramp fixed with a wedge-type anchor. Good adjoining provides strength and hides joint places. It has one fixing point. To fix it to bricks or concrete it is necessary to use anchors and 200mm or 250mm screws.
SCREWS WITH ANCHORS – Possible length: 200mm or 250mm.
RAIN WATER PIPE CONNECTING ELEMENT – is used to join cut rain water pipes. Provides reliable, firm junction.
T-SHAPE BEND – is used to join two rain water pipes into one. It has an additional side junction with adjustable angle from 50 to 80 degrees.
RAIN WATER PIPE GUIDE is used to direct water to other container.